It should be located in the oil pan. On my ranger its on the drivers side.
The 1994 Ford Ranger pickup truck map sensor is located behind the dashboard, on the passenger side of the passenger compartment. The map sensor is contained in a dust free box.
looking for an answer to this question "Where is the MAP sensor located in a 6 cylinder Ford ranger 1994 Help! www. motorcraft. com (no spaces) does not list a MAP sensor , it shows an AIR MASS SENSOR which I assume is the MASS AIRFLOW SENSOR which would be mounted close to your air filter housing
I'm not a mechanic / technician but the engine wiring schematic for the 3.0 liter V6 engine in a 1994 Ford Ranger that is in my Chilton's repair manual does not show a knock sensor
below throttle body
According to www . motorcraft . com ( no spaces ) the IAT sensor is a thread in type for the engines in a 1994 Ford Ranger - so threaded into the upper area of the intake manifold somewhere
under the hood driver side
located on the transaxle.
Unfortunatly there isn't one. I am actually looking for an aftermarket oil level sensor to install in my 1994 silverado.
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
There is no such thing as an oil pressure switch on your 1994 Ford Ranger 3.0 liter engine. There is an oil pressure sensor. The oil pressure sensor can be found on the left-hand side of the engine.
Yes, it does have EGR. The EGR Valve is located on the driver's side of the intake manifold. It also uses a DPFE sensor as well.
Where is the vehicle speed sensor pick up located in a 1994 Pontiac Trans Port?