0
looking for an answer to this question "Where is the MAP sensor located in a 6 cylinder Ford Ranger 1994 Help! www. motorcraft. com (no spaces) does not list a MAP sensor , it shows an AIR MASS SENSOR which I assume is the MASS AIRFLOW SENSOR which would be mounted close to your air filter housing
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the temperature sensor on a 1994 Ford Ranger?
It is near the thermostat. can you give a better location left or right of thermostate above or below it
Where is the map sensor 1994 ford ranger 3.0?
The 1994 Ford Ranger pickup truck map sensor is located behind the dashboard, on the passenger side of the passenger compartment. The map sensor is contained in a dust free box.
Where is the IAT sensor on a 1994 Ford Ranger?
According to www . motorcraft . com ( no spaces ) the IAT sensor is a thread in type for the engines in a 1994 Ford Ranger - so threaded into the upper area of the intake manifold somewhere
Where is the 1994 ford ranger fuel pump location?
In the fuel tank.
Where is the Plug for the sensor read out on a 1994 Ford Ranger?
under the hood driver side
Coolant temp sensor location on 2001 ford ranger 2.3l?
yes yes
IAT sensor location on 2004 Ford Ranger 2.3L?
It's located with the MAF
Does a 94 Ford Ranger with a 2.3 engine have a knock sensor?
I'm not a mechanic / technician but the engine wiring schematic in my Chilton repair manual for the 2.3 in a 1994 Ford Ranger does not show a knock sensor
Location of knock sensor on 4.0L 93' ford ranger?
It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )
Where is the Location of map sensor on 1994 460 ford?
The map sensor is located on the intake manifold of a 1994 Ford. It could also be located on the plenum by the throttle body.
97 2,3 vina engine ford ranger xlt map sensor location?
Radar
On a 1994 ford ranger the crank position sensor it brakes the magnet off the sensor and there is not enough adjustment to stop it how can you stop that?
On a 4.0 V-6 the crank position sensor is in a fixed location and cannot come in contact with the crank if it is installed correctly.
