1994altima doesn't have a timing belt. The 1994 Nissan altima has a timing chain. Which is much more durable than a timing belt.AnswerIf you think your car is out of time...check the distributor first. When it goes out it sound like the car is out of time. AnswerThe engine has to be removed to replace the timing chain; expect about $1,000 for labor alone.
Maybe your alternator needs replacing.
i have a 1994 altima gxe and it has a chain. wut engine size is it? is it dohc?
How can you tell if a crank sensor has gone bad on a 1994 Nissan altima
Where is the neutral safety switch on a 1994 Nissan Altima?
Were is the timing mark an a 1994 Nissan sentra 1.6l?
One reason why your 1994 Nissan Altima could be sputtering at an idle is because of your spark plugs. It could also be caused by the idle sensor.
There is no carburetor located on a 1994 Nissan Altima because it uses fuel injection. A carburetor is typically located on top of the engine on the intake manifold.
The 1994 Nissan 4x4 2.4 four cylinder has a timing chain.
The 1994 Nissan Altima muffler will cost approximately $50. There are several qualities of muffler's available. A stainless steel muffler will cost approximately $200.
It is important to have a car that has decent fuel economy. A 1994 Nissan Altima gets 24 mpg city, and 30 mpg highway.
need diagram for replacing timing belt
go to a Nissan dealership and they should be able to help you
how to change the brakes
it is inside the distributor
The knock sensor advances the timing to optimize fuel efficiency. When it goes out, your gas mileage goes down.
no .. i used to have a Nissan altima 1998 and the rims are only for altimas
The fuse box diagram for the 1994 Nissan Altima is often located on the inside cover of the fuse box. You can also find this diagram online at places like Nissan Forums and Nissan Help where people upload the diagrams.
An engine control diagram for a 1994 Nissan Altima can be found in an automobile repair manual. Both Chilton and Hayes repair manuals are available for most vehicles.
May be computer controlled and not adjustable
Axle Nut .. 1994 Nissan Altima ... 36mm socket. You will need a 1/2" Impact or breaker bar. Most parts stores have a loaner program where you can borrower this socket.
I am not sure of what year you are talking about. But the 1993 and 1994 Altima does not have a crankshaft sensor(crankshaft position sensor) .....
you have a vacumn leak.
it is right below on the intake, on the blocks backside.
take old out put new in
Timing chain has stretched due to age and mileage of vehicle