Probably around 3800-4200lbs
how do you adjust rear brakes on a 1986 chevy silverado?
700R4 from 1986 to 1992 should work
In front of the radiator. pull off the grill
it will probably be 3.73
probably a 350 small block
I need the wiring diagram on a 1986 Chevy silver ado dual fuel tanks
In glove box along with options for truck.
18-25 if your not towing anything
That year don't have one.
Do you have automatic locking hubs on the front axles?
Auto Zone and Advance Auto
The 350 is the small block, and in 1986 it would be GM corporate blue.
Yes they did, I own 1 myself.
the widest one on the timeing chane cover right in the middel of it
If it is an automatic transmission, Dexron III or Mercon are both acceptable.
it has 1 short bolt and 1 long bolt
350 or 305 depending on rear end
A/C Belt Power steering belt. Alternator belt Air pump belt.
Yes you can, but don't drive over 50 to 55 MPH
yes, you may have to do some fabrication on the crossmember to the frame but it will bolt right up to engine.
I found one source that says a 1986 Chevy Celebrity has a curb weight of 2714 pounds. Different options would change that weight.
Freshly rebuilt with good carburetor at 5000 rpm, 200 horsepower maybe a little more
i think my 86 was about 1700kgs wet
71 Chevelle right at 3800 lbs. 86 mont about 3400
It is a 5" lug pattern. I looked it up on some classic Chevy website. I can't think of the URL for it at this moment though.
Its not a kickdown cable its a throttle pressure cable. Take it to your local shop. They might do it for free. If not they might do it for an hour of labor
go to autozone.com..theres a page of nothing but mannuels for everything you will ever need.. hope that will help you out..
If it's an 1987 or newer then you will find it inside of the fuel tank and it will be an electric pump. If it's an 1986 or older then it will be bolted to the passenger SIDE of the engine towards the front bottom.
Figures from NHTSA crash testing list the 1987 Chevy G20 at 5456lbs, this should be close to the figure for the 86 model.
Need to make sure that you have fire-spark at the plug wire when cranking engine. Then ask your question again I we will answer you, and see if we can help you.
Replace water pump for an 1986 Chevy Nova?
5 QTS. with a new filter.
If you have a regular size bed and single cab with dual tanks, 18 gals each. Short beds are down to 16 gals. I have been able to get 20 gals in the regular cab.
the 1986 Chevy truck 305 HO produced 180 hp
need picture of fuseblock for 1986 chevy k10 pickup
It is screewed into the top of the engine block right behind the distributor. About 3 inches long with an electric wire pluged into the end of it. HARD TO SEE and to remove.
go to the library and get a chiltons repair manual for Chevy 1986.
My 1986 GMC High Sierra 1500 stock transmission is a 700R4. My 1986 GMC High Sierra 1500 stock transmission is a 700R4. it could also be a th 400
Regular coolant or a global coolant will work also. Thanks for your answer. I failed to mention that I have yellow in radiator now, should I stay with yellow? Is there harm in mixing colors?
The differential on a 1986 Silverado can be replaced with any year differential from 1973 to 1987. The replacement differential must be either a 2-wheel drive or a 4-wheel drive, depending on the type that needs to be replaced.
if you replace the alternator will you also be replacing the voltage regulator
it should be 1 ton including the weight of you and a passenger but you can usually haul a little bit more but to be safe 1 ton! 2000 lbs
NO. 1988 is when chevy changed everything.
The spark plug gap for a 1986 Chevy Celebrity with the 2.5L 4 cyl engine is .060".
The gross weight of a 1986 LWB GMC truck is = 16500lb.
where is the fuse box in a 1986 camaro
If they are the same size it would seem that they would fit. But do you really want to put a car tire on a truck? Truck tires have different weight carry values than car tires. Therefore putting a car tire on a truck might alter its weight hauling capacity.
Disconnect the fuel line from the carb with a 5/8" line wrench then unthread the fitting in the carb with a 1" wrench. The fuel filter is inside that fitting. Take note how the filter and spring are assembled into the carb for reassembly.
NO. You will find the fuel pump on the passenger front SIDE of the engine.
go to chuck's Chevy pages .com the answer should be there.