more fuel gets in to cylinders for more power
In short, More Power.
4 valve sohc/dohc heads and hemi heads are both cross flow heads. It is because the intake valve is across from the exhaust veruses inline as with regular 2 valve wedge heads.
There are ( 2 ) cylinder heads on your 4.0 liter over head valve V6 engine
What is the difference between servo valves and proportional valvesThere are no strict rules between Servo valves and proportional valves, because the proportional valve"s performance is getting better, gradually close to the servo valve, so in recent years there has been proportional servo valve. The difference between servo and proportional valve can be divided into the following points: 1. Drive different.2. Different performance parameters.3. Different valve structure and precision.4. Function in different types.5. Valve rated pressure drop are different.So people can choose the different kinds of valves on the basic of you require.Angad kumar pandey
If each coin is a different color, then there are 32 possible outcomes. If you can't tell the difference between the coins, and you're just counting the number of heads and tails, then there are 6 possible outcomes: 5 heads 4 heads 3 heads 2 heads 1 heads all tails
1.) in conventional solenoid , the force is not costant...wheras in proportional .it is. 2.) proportional valve fills the gap between conventional and servo valves 3.) proportional valve can take infinite spool positions 4.)proportional valve cannot take high degree if valve performance
-5
PCV Valve is right under the alternator. 1. Disconnect the battery. 2. Take the serpentine belt off. 3. Take out two alternotor bolts. 4. Its right in between the 2 heads. Makesure to check the groomet for PCV if hardend remove that too.
There is a super short length. This runs along the outside, lower ridge. Then there will be 2 in between, they each go on either end, under the valve cover. The longest ones will go down the center, under the valve cover.
Relief valve always position in the suction line in oreder to relief the extra pressure, while safety valve is always placed at discharge line to release excess pressure.I would take that one step further by stating that a " RELIEF VALVE" is one that is "meant" to be lifted off its seat, as opposed to a "SAFETY RELIEF VALVE" which is not!DIFFERENCE BETWEEN RELIEF VALVE AND SAFETY VALVE:1. Releif valve is applicable in the fluid system.safety valve is applicable in the gaseous system.2.Relief valve opening is directly proportional to the pressure rise.Safety valve opening is will happen at after reaching the setpressure.3.Mode of relif vlave line is again connected to the suction.But in the safety valve is just vent-out there is no connection tosuction.
What is the difference between 2-pentanol from 3-pentanol?
there is no difference