Crankcases and PCV Valves
Chevy S-10
Buick Century
Ford Ranger XL

Where is the PCV valve on a 1993 Buick Century 3.3 liter?

899091

Top Answer
User Avatar
Wiki User
Answered
2004-12-07 17:12:02
2004-12-07 17:12:02

PCV Valve is right under the alternator. 1. Disconnect the battery. 2. Take the serpentine belt off. 3. Take out two alternotor bolts. 4. Its right in between the 2 heads. Makesure to check the groomet for PCV if hardend remove that too.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Replace ignition switch for 1993 buick century?

should be right underneath the throttle body to the right of the intake.

On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.

Center of the steering wheel.

The spark plug gap for a 1993 Buick Century is: .045 for the 4 cyl 2.2 engine .060 for the V6 3.3 engine

it is located on the right side behind the head light and it is the last relay next to the radiator

On the engine side of the firewall and on the passenger side of vehicle. You should see two hoses. One goes all the way to the radiator and the other makes a U-turn - that one is your heater valve.

In the top of the valve cover , on the drivers side of the engine , near the rear of the valve cover , next to the firewall

There is a sticker on the inside of the trunk lid that has that information.

Underneath the car, inside the fuel tank.

Between passenger front wheel and water pump

it is distributorless no cap to replace has coil packs

The block and valve covers were black.The block and valve covers were black.

The Idle Air control valve is located on the side of the throttle plate.

It is under the air cleaner system, on the front of the engine.

the Century first joined the Buick lineup in the late 1930s to emphasize the car's advertised top speed of 100 mph. Without modification that has remained the top speed of the stock vehicle.

Quad-Drive module or QUAD-DRIVE No.1 error

the catilatic converters could be stopped up.

According to the Haynes Repair Manual , it says the following: 2.5 liter is 4 quarts All others 4.5 Quarts

You don't have one jeep stopped putting them on the 4.0 in 1990

1993 and before it is R-12, 1994 and later its R-134a

The valve adjustment specs on a 1993 Accord are as follows Intake-0.0008 to 0.0018 inch Exhaust-0.0022 to 0.0031 inch these specs are for the 1993 Accord ONLY!! if you have a 1990-1992 these specifications change.

Just above cylinder no. 3 between engine and engine firewall. Look in behind the coil pack. Also look for sticker on fender well detailing emission components.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.