Related to a battery and open load is the battery just sitting there without anything connected. A short is a very low resistance attached to the tow terminals of the battery. For example, a wire connected across the battery terminals would constitute a short.
Both are giving the data about storage capacity of a battery. For Ex. 12V 7AH Battery will run 7 hours if you are driving the load of 1Amp continuously. But 12 12AH Battery will run 12 hours if you are driving the load of 1Amp continuously.
The capacities of batteries are rated in amp hours. The higher the amp hour rating of a battery the longer the device connected to the battery will operate. Depending on what the connected load draw in amps is, will determine how long the connected device will operate.
The amperage drawn from a C cell battery is governed by the load resistance. The lower the resistive load the higher the amperage draw from the battery.
That is true but not very - the excess of electrons at the negative terminal is small. The important thing is that if you place a load (radio set, light bulb etc.) on the battery the electrons flow through the load and this movement is supported by energy supplied by chemical action in the battery.
Only without a load. Putting a load on it upsets the equilibrium.
'Voltage' is simply another term for 'potential difference', and an electromotive force is the open-circuit, or no-load, potential difference of a source such as a battery or generator.
A terminal potential difference is the potential difference appearing across the terminals of a voltage source, such as a battery or a generator, which varies according to the load supplied.When the battery or generator is off load (i.e. no load is connected to it), the terminal potential difference is equal to the electromotive force of that battery or generator.The terminal potential difference tends to decrease as the load current increases, due to a corresponding increase in the internal voltage drop of the battery or generator.
Both are giving the data about storage capacity of a battery. For Ex. 12V 7AH Battery will run 7 hours if you are driving the load of 1Amp continuously. But 12 12AH Battery will run 12 hours if you are driving the load of 1Amp continuously.
well the difference mainly exists in the method of finding them , these are :-1. in finding DC load line :-open all AC sourcesopen all the capacitors2. for AC load line:-open all the Dc sourcesshort all the capacitors.
no difference
nada
nada
nada
During load test the readings/performance could be monitored during load variation from zero 100% and short circuit.
land
sudden load differ from impact load by the velocity of loading
12v , 7Ah means its the capicity of Battery , if load current is 1 amp then battery runs for 7 hrs. AH = Ampere* Current. 12v, 7ah 20hrs its shows load current is 7/20 amp.