the ecm is the cars electronic control module and the pcm is the cars powertrain control module. the ecm controls the ignition and fuel injection system so that when you get close to the speed your cars original tires are safety rated for, your ecm will shut down fuel injection and ignition prcessses until you return to the safe speed. the pcm is a cars powertrain control module. it stops your engine rpms from reaching critical levels. both are computers in your car that enable you to drive safely, and just like any other computer they can be modified, most service to your car now requires the mechanic to diagnose your car like a doctor by plugging into these computers to see whats wrong.
P1694 - No CCD message received from ECM. This is a bus communication failure between the PCM and ECMP1694 - No CCD message received from ECM. This is a bus communication failure between the PCM and ECM
there is many difference
If the Pcm sets a code saying that it's companion has dtc, you need to check the Ecm because it will have a code in it.If the Pcm sets a code saying that it's companion has dtc, you need to check the Ecm because it will have a code in it.
Either the PCM, or ECM will have another code in it. Diagnose and repair that code and the companion dtc set code will go away.Either the PCM, or ECM will have another code in it. Diagnose and repair that code and the companion dtc set code will go away.
The PCM (or ECM) is located on the interior of the car on the passenger side. To access the PCM/ECM remove the kick panel just beneath the glove box and it is right there. Disconnect the three electrical harnesses and and sucuritity clip and it's out.
PCM = Power Control Module. It is the car's main computer/brain. Also can be referred to as the ECU or ECM.
ECM/PCM Power Relay Sense Circuit /Open
Is this a Factory LT1? In your 1992 Z28?
The fuse that works the cooling fan(s) depend on the make/model/year of the car. In general cooling fans are controlled by a fan relay & fuse or by the ecm, bcm,pcm (ecm/bcm/pcm are computers)
11: No crank signal to computer. Fault in wiring between crankshaft position sensor (CPS) and ECM ( PCM or computer ) or faulty CPS.12: Battery disconnected. Battery or power to the ECM disconnected in the last 50 key cycles.66: TCM to PCM failure. No message from the Transmission Control Module (TCM) to the Powertrain Control Module (PCM)
Trouble code P1693 means: A companion DTC was set in both the ECM and PCM
PCM Location where is the ecm or brain in a 95 buick roadmaster