0
What is the distributor point setting for a 1968 Plymouth 273?
Wiki User
∙ 14y ago
If you have a dwell meter the dwell is 28 degrees to 32 degrees for the points, I usually set them at 30 degrees, the gap is pretty much the width of a paper match .
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the dwell setting in a 1968 Plymouth fury III with a 318 motor?
the dwell specs are 28 to 32 degrees, I always just set the dwell at 30 degrees.
When was Plymouth Road Runner created?
Plymouth Road Runner was created in 1968.
Will a 1968 Plymouth roadrunner trunk lid fit on a 1969 Plymouth roadrunner?
Yes
Did Plymouth ever make a roadrunner 500 in 1968?
no.
How do you draw a 1968 Plymouth satellite?
Perhaps with a pencil...
Firing order for 1968 Plymouth satellite 273?
A 1968 Plymouth satellite 273 is a classic automobile. Its firing order is 1 5 3 6 2 4.
What motor does a 1968 Plymouth fury III have?
any engine Plymouth made was available in the fury in 68 if you ordered it.
Where is No 1 on a 1968 289 cubic inch distributor?
The marked # 1 position on the distributor cap faces to the REAR
Is a 1968 and a1969 Plymouth fury frame the same?
The 1969 had a 1" longer wheelbase than the 1968
Where is the transmission modulator on a 1968 Plymouth fury II?
A 1968 Plymouth Fury II does not have a Transmission Modulator as such. The throttle linkage on the A904 a A727 transmissions performs a similar function to a ( Vacuum ) Modulator .
What is the points setting for a 240 cubic inch ford?
the dwell is 35 to 40 degrees ---------------------------------------------------------------- ( on a 1968 F series W / EC - point gap .027 / point dwell 35 - 40 ) and ( on a 1968 F series WO / EC - point gap .025 / point dwell 37 - 42 ) for 240 C I straight 6
How do you remove 1968 vw beetle distributor?
First unhook the battery. Next, remove the distributor cap and unhook the wire that runs to the coil. Then loosen the distributor clamp (10mm nut) and pull the distributor out.
