answersLogoWhite

0


Best Answer

When replacing your brake pads on your Ford Explorer, you first need to jack up the vehicle and remove the tire. This will give you access to the brakes. Locate the caliper, remove the two bolts and slide the caliper off. Inside the calipers are the brake pads.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the easiest way to install brakes and rotors on a 1999 Ford F150?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

If you need new brakes and rotors on your 1999 Chrysler cirrus do you need any other parts?

the only other parts you might check when you have it pulled apart,are the wheel bearings.the bearings etc are in the rotors but do not come with them when you buy rotors.if you are not careful you will trach the bearing races and seal on the back side of rotors when trying to remove them to install in new rotors


Replacing front rotors on a Honda accord 1999?

take brakes off and calipers off, next rotors should come off easily.


What kind of brakes does Mitsubishi Galant have Does it have rear brakes and rotors?

I believe the awnser varies on what model you have... I have a 1999 galant GTZ mine has disc ( rotors ) front and back, The rear has the disc drum combo for the parking brake... Hope this helps


How do you replace front brakes and rotors on a 99 Chevy Cavalier?

Remove the tire and wheel from your 1999 Chevy Cavalier. Remove the brake spring and the caliper. The brake pads will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to install the new brakes and rotor.


What causes a 1999 Chevrolet Malibu to shake only when brake is applied when in drive?

if you are driving and you go to stop, then that means that the front rotors are warped. if the front rotors are bad, you will feel a pulsation in pedal while applying brakes. change rotors on front.


Where can you find a diagram of Ford F-250 front disc Brakes?

Where can I find a diagram of a 1999 Ford F250 front disc brakes before I attempt to install them?


Why does your 2001 Jeep Grand Cherokee Laredo steering vibrate when you apply the brakes?

Warped brake rotors. This is a very common problem for the 1999-2004 Grand Cherokees. You will need to have your rotors replaced, or resurfaced. The best resurface method is with an on car brake lathe.


How do you change brake rotors for 1999 olds intrigue?

Remove the wheels of the affected rotors. Remove the calipers and hang from a bungee or other strap to prevent stress on the brake hoses. Remove the caliper brackets. Remove the rotors. Clean the rust from the hub flange. Clean the anti-rust from the new rotors. Install the new rotors. Install the brackets. Install the new pads (if you are using new pads). Compress the caliper piston, one side at a time, using a c clamp or actual piston tool. Install the calipers. Install the wheels. MAKE SURE YOU PUMP UP THE PEDAL BEFORE YOU PUT THE CAR IN GEAR. Many people have taken out walls for forgetting this step.


What is the minimum thickness for rear brake rotors for a 1999 Volkswagen euro van?

If you mean for checking if you need new brakes, just feel it, if there's a lip around the outside that is getting pretty define your probably going to need brakes pretty soon


How do you change front axle seals on a 1999 Jeep Cherokee Sport?

You have to remove the brakes, rotors, wheel hubs, axle shafts, diff cover, and differential carrier, seals are on the inside of the axle tubes.


Why would the back brakes on a 1999 Neon heat even though they are new and how do you adjust the parking brake?

there is a possibility that you have a malfunctioning master cylinder. my dodge neon ate up two sets of pads/rotors and drums before we found that the master cylinder was causing the brakes to stick.


How do you change 1999 ford explorer front brake rotors?

remove the brake caliper and the rotors come right off