answersLogoWhite
Timing and Firing Orders
Honda Prelude
Honda Prelude SI

What is the firing order for a 1991 Honda Prelude si 2.0L?

394041

Top Answer
User Avatar
Wiki User
2006-01-09 13:02:11
2006-01-09 13:02:11

the firing order is 1,3,4,2 on the distributor, the second connection going to the front of the car is 1, the fourth connector is 3, the fifth is 4, the first connector is 2, the center one is the coil.

1

Related Questions

User Avatar

Honda Civic four cylinder engine all share the same pattern for the firing order. The firing order for a 1991 Honda Civic is 1-3-4-2.

User Avatar

reset the brakelamp light on the dashboard - Honda prelude 1991

User Avatar

show me picture of where the water pump is located on 1991 Honda prelude si

User Avatar

The diameter of the rims for the 1991 Honda Prelude is six inches. Check out a local car dealership for more information about the car or if interested in purchasing it.

User Avatar

Honda Prelude 1979-1991 have the same bolt pattern so they will "fit". Then it just depends on the width of the wheel and the offset (the distance between the centerline of the wheel and the plane of the hub-mounting surface of the wheel). Honda Prelude 1992+ wheels will not fit.

User Avatar

Most firing orders of conventional four sylinders is: 1-3-4-2

User Avatar

firing order for a 1991 cadillac deville

User Avatar

A 91 prelude gets about 26mpg in the city and about 30 on the highway.

User Avatar

How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L

User Avatar

On a 1991 Honda Prelude 2.1SI, the Oil Sensor is located slightly above the Oil Filter.

User Avatar

While owning a car, it is important to know its firing order. The firing order for a 1991 Toyota Corolla is 1 3 4 2.

User Avatar

They're 14x5.5 (4x100 bolt pattern) stock.

User Avatar

the firing order should be 1,3,4,2.

User Avatar

Fixing a 1991 Honda Prelude varies depends on what exactly is wrong with the car. If there is a CEL take the car to a have a diagnostics test done. This will help narrow down the problem to the source.

User Avatar

Would have been built for R12, can be converted to R134a.

User Avatar

yes it will fit but check for the offset and width

User Avatar

1-3-4-2 is the firing order. Starting from the driver's side of the engine,and going toward the passenger side of the engine, the cylinders are numbered 1-2-3-4.

User Avatar

Knowing the firing order can help a person troubleshoot engine problems. The firing order for a 1991 Geo Metro is 1-3-4-2.

User Avatar

As with all inline four cylinders, The firing order is 1342.

User Avatar

With the 2.0 and 2.1 the only tranny that will swap is from the 2.0 or 2.1

User Avatar

You can't aprrently on a hyrdraulic clutch, which these have that adjust automatically.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.