You will first need to fill the fork completely with fork oil. Fork should be collapsed with the fork spring removed. Bleed the air out of the inner cartridge by slowly cycling the damper rod through it's full stroke. From this point you can set the oil level to the correct height measured from the top of the outer fork tube. Factory specs are: Minimum Height: 155mm Standard Height: 139mm Maximum Height: 117mm
From my under standing if your riding MOTO, with a fork oil level gauge you measure put 110 mm.
No, it wont.
5o ml each leg fork.
70-75ml ATF
70-75ml ATF
120mm from the top
The front forks must be removed from bike to check or change the oil. Clymer m457-2 1997 104mm standard ,min 81mm, max 120mm
There are various levels for the 1979 RM125N Air Fork Oil Capacity Standard 392mm - approx 13.2 US Ounces Low Level 376mm High Level 424mm
not sure about newer models but the old models take 280 ml in each fork
yes but the honda cr 125 is a 2 stroke
The mixture would be 20 to 1 for a Honda 125 2 stroke