1. Tighten head bolts in sequence to 34Nm/25lbft.2. Turn each bolt 90 degrees.3.Tighten to 90Nm/67lbft.If while turning through 90 degrees 90Nm/67lbft is reached stop tightening that bolt.NEW HEAD BOLTS must be used.
the answer is 56
Torque Setting for VS Commodore Harmonic Balancer Bolt- between 270-320 NM. The Best way is to check the bolt torque setting before you remove it.
how much torque on a head bolt
5 3 2 87 1 4 6 3.1 cylinder head bolt sequence
To replace the belt tensioner on a v6 commodore you start by removing the fan belt by using a 18mm spanner and rotating the pulley assembly anti clockwise. Undo the bolt by holding the tensioner pulley on and use the 18mm spanner to turn bolt clockwise to undo threaded. Place new pulley onto shaft, drop some Loctite onto bolt and screw in. Rotate pulley anti clockwise and put the fan belt back in.
75-82 ft lbs
head bolt location for 3.8 liter v6 ford eng. non-torbo did not payattion to lengith of bolt in proper location please help
The 1995 Chevrolet 3.1 liter V-6 engine head bolt torque specifications is 160 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
The Firing order for VT V6 commodore is 1-6-5-4-3-2, this is the basic firing order cycle for most VT v6 commodore.
The control fuse on a 95 VS Holden Commodore V6 is located within the fuse box. The fuse box is located between the right strut and the right headlight.
The head bolt torque specifications, for your 2002 Pontiac Grand Prix, is 160 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
No the bolt pattern for the v6 and the v8 are different