It is important to know the head bolt tightening sequence and the torque of a vehicle. For the Fiat Punto it is 20nm, 30nm, 90 degree turn, 90 degree turn, then in order 8,6,2,5,10,7,3,1,4,9.
I would recommend that you consult a repair manual for torque values as well as tightening sequence
Rover 20T2N 2.0Ltr Diesel engine Cam cover torques are listed as 12 Nm. No tightening sequence is listed .
always start in the middle and work outwards,, head stud torque is 115 then 145
Just criss-cross on the bolts and don't tighten them all in sequence, just like tightening lug nuts on a wheel.
get specs from your local librarys technical isle look up specs and tightening sequence.
20nm +180 degree +180 degree
There will be a diagram of this in every car's manual. -Follow that specific diagram to order of tightening and torque specs.
Ineed the torque sequence and tightening specs for a 92 GM 3800 intake.
Tighten in a criss cross pattern to 70 lb/ft of torque. Work slowly tightening a small amount at a time until you reach 70 pounds.
hondahookup.com has manuals
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
which one? The head bolts? Engine to transaxle? And, are you really asking what the tightening sequence and/or torque rating is?
45,65,65 ft lbs then 90 degrees.
torque specs of what?
Breakaway torque is the torque required to start the initial movement, in the loosening direction, of a bolt, screw, or nut from its (non−loaded) at rest position with the locking element engaged. Tightening torque is the torque necessary to move the bolt, screw, or nut along its threaded length in the tightening direction.
Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .
General torque sequence starts from the most center-mounted bolt and work either cross-ways or spiral-ways outwards from there. I woul suggest tightening in 3 steps, ie- if the final torque is 80 Ft.Lbs, tighten all to 20, then all again in sequence to 50, then again all in sequence to the final 80 ft/lbs.
Tighten the valve cover retaining bolts in sequence, torque them to 71-106 inch lbs. (8-12 Nm).
IF YOUR CAR LEAKS WATER AND HEAT BLOWS COLD AIR WHAT THE PROBLEM
Get a manual on your car from the parts store. It will help on the next repair. They are about $18
hondahookup.com has manuals u can download with the info u need