Want this question answered?
the return spring on the clutch pedal assembly must be replaced.
How do you install a cluch pedal spring on a 93 honda accord
Adjustments is behind top of the clutch pedal. Clutch spring should be under the car on the transmission closest to the motor block, next to the slave cylinder.
clutch pedal over -centre spring pressure
The clutch pedal has an assist spring and return spring. The assist spring tension must be adjusted to create a balance point at which the clutch pedal will over center and return to the fully disengaged position. It is also possible that the system may have air or the push rod attached to the pedal may be out of adjustment.
you need to change the spring in the clutch cylinder ,you find more info on at alfa .net
1. Remove clutch pedal assembly from car. 2. Remove fulcrum bolt. 3. Install clutch assist spring. 4. Align fulcrum (say, with a screwdriver tip). 5. Insert fulcrum bolt. 6. Reinstall clutch pedal assembly.
It would hurt it. Changing the spring will make the pedal harder to push down. The spring pulls the pedal up.
GO to www.LMCtruck.com & order there free parts Catalogs & (just) remove the heavy duty spring on the clutch assembly & R&R the bushing,but B careful...
A reverse clutch setup is when the clutch assembly is normally in the "release" or "free" mode when at rest, as opposed to the usual "normally-engaged" arrangement. In other words, the spring is pushing to dis-engage the clutch and pedal pressure is required to connect the engine to the rest of the drive train. In a normal automotive clutch system, the driver has to push in the pedal to release the clutch, then let go of the pedal to engage it.
You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.
Low of hydraulic fluid. Check the reservoir.