Starters and Ignition Systems
Spark Plugs and Wires
Pontiac Firebird
Chevy 350

What is the ignition timing point gap and spark plug gap for a 1975 Ford 302 V8?

747576

Top Answer
User Avatar
Wiki User
2006-01-22 22:36:16
2006-01-22 22:36:16

Let me know the type of heads you are putting on the 302 and if they are 2V or 4V heads and if possible what type of vehicle was this 302 originally in. Spark plug gap for my 2V truck is .044

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

6, to 8 degrees advanced, or BTDC., will work best.

User Avatar

The 1975 Ford F150 4.9 L ( 300 cubic inch ) straight 6 has electronic ignition , it doesn't have points

User Avatar

It should have electronic ignition.

User Avatar

You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.

User Avatar

Yes But the 1975 Ford F150 electronic ignition system is unreliable the newer F150 is more reliable and works longer than the 1975 version.

User Avatar

Spark plug gap for 1975 Honda CB125s is: 0.6 - 0.7 mm (0.025-0.028 inch) Ride safely Ahmet

User Avatar

1975 for the HEI (High Energy Ignition) system (no more ignition points)

User Avatar

Depends on what type of ignition system you have. If you have a vehicle made before 1975 with points, about .030- .035 is an acceptable gap. If you have an electronic "hei" ignition you can run larger gaps .045-.060 is common. On a street driven car there is little to be gained in power or mileage by fooling with plug gaps, unless the vehicle has ultra high compression, is turbo or supercharged, is running extremely lean, or has a weak ignition. Most spark plugs will be gapped correctly right out of the box.

User Avatar

The Turning Point of Jim Malloy - 1975 TV was released on: USA: 12 April 1975

User Avatar

The correct plug gap for the 1975 model, 75 hp Evinrude, is .032 in.

User Avatar

According to one of Fords websites : The 360 cubic inch / 5.9 liter , V8 engine in a 1975 Ford F-150 has a spark plug gap of : ( .044 inch )

User Avatar

If the bike has a "points" ignition system, check the starter circuit to see if it has an "ignition resistor bypass" to give a hotter spark when starting. This was pretty common on cars of that era. My 1975 Triumph motorcycle is set up with points and a bypass. Check the service manual (or do a visual by tracing wires backwards from the points) to see if the bike has a ballast resistor -- jump it to see if it will run and, if so, replace it.

User Avatar

best spark pluguse a ngk.cu they are the best spark plug for that year.and they also workk very well.so i hope this helps you out.I have a 1975 Yamaha DT 175 that I have owned since 1976 when I bought it new. I have also owned a 1975 Yamaha DT 125, Dt 80 and MX 175. Being that I've owned all these bikes and that I still own a 1975 Yamaha DT 175 that I bought brand new, I know what spark plug it takes. It takes a NGK B8ES. A Champion N3C can also be used.

User Avatar

One degree above top dead center.

User Avatar

Doctors' Hospital - 1975 Point of Maximum Pressure 1-1 was released on: USA: 10 September 1975

User Avatar

MacGregor Point Provincial Park was created in 1975.

User Avatar

The factory plug type is A/C R44TX and Gap is 0.060

User Avatar

the parts store can help you on this question.

User Avatar

They came equipped with a standard single breaker point with a vacuum advance. Electronic ignition (HEI) didn't become standard for the full GM lineup until 1975.

User Avatar

6 degrees BTDC / Before top dead center


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.