0
This question is un-answerable. It does not include transmision model, Engine type and displacement, Vehicle Wheel base. Because of the age of the vehical and the many transmisions that will fit and how cheap parts are for used parts it would be easier to crawl underneath with a tape measure.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Is it a chain or a difenrential in a 1989 Honda fourtrax 300?
Differential with a drive shaft.
What is the shaft length of 1989 90 hp outboard 2 stroke motor?
The most common shaft length for engines in the 90 hp range is 20 in., refered to as a long shaft. They also come in 25 in., extra long, and for special applications, 15 in. refered to as a short shaft.
How do you take the 4 wheel drive off on a 1989 Chevy Blazer?
you dont, if you want to disconnect it then remove your front drive shaft.
How do you remove drive shaft and universal joints Chevy silverado 1989?
take out the four bolts where the drive shaft meets the rear end,then move the driveshaft foreward about one inch,drop the driveshaft down and pull it out.
What is the rear gear ratio in a 1989 Chevy Cheyenne?
The rear gear ratio of a 1989 Chevy Cheyenne truck is between 2.73 and 4.56. This is the number of times the drive shaft rotates in relation to the tires.
Is the 1989 Kawasaki voyager 1200 shaft driven or chain driven?
shaft
Where do you put transmission fluid in a 1989 Honda Civic?
If it's automatic, through the dipstick hole & if it's manual, special bolt on transmission. (close to the drive shaft)
Will the tail end from a 1989 Chevy Four Wheel Drive transmission fit correctly on a 1994 Two Wheel Drive Chevy Transmission?
NO. The 2-wheel drive transmissions have a SHORTER CENTER SHAFT in them because there is no transfur case that goes on them. The 4-wheel drive transmissions have a LONGER center shaft that sticks out further because it has to go into the transfur case. You can take both transmissions apart and switch the center shafts and then it will work. It's NOT about the tail end of the transmission.
Where is the over drive solenoid on a 1989 Chevy Corsica?
where is the over drive solenoid located on a 1989 Chevy Corsica
Where is the cam shaft sensor on a 1989 Oldsmobile 88?
in the intake where the dist. should be on the front of the engine
Where is the cam shaft sensor located on a 1989 dodge B250 Ram Van?
It is inside the distributor.
Where is the crank shaft sensor on a 1989 2.5 Plymouth sundance?
This car only uses the sensor in the distributor.
