Want this question answered?
Volts * Amps = Watts 12V * A = 150W A = 150W/12V A = 12.5
No, you can not charge a 3V battery with 12V charger.
The formula you are looking for is W = I x E.
Yes. However you will not be able to see anything as the 12V 4.5A power supply does not come with a screen.
Using a 12v 600ma source is allowing 12 volts and 600 amps of power. If the device requires a 12v 500ma source, the larger source is acceptable. Please note that it will only be drawing on 500ma of the available 600ma.
A 12v inverter is widely used in the domestic electrical appliance world to convert a 12v system to a higher voltage. So in other words you can use any appliance on a 12v system as long as you have the proper inverter.
Yes
12 volt electical system
You can replace a battery with a battery of the same voltage but greater capacity as long as it will physically fit.
12v 1000mA means that the maximum output of that unit is 1000 milliamps at 12 volts. 12v 150 mA means that the maximum output of that unit is 150 milliamps at 12 volts. So if you need 150 milliamps at 12v either will do. BUT if you need over 150 milliamps at 12v then you must go for the 1000 mA unit. By the way there are 1000 milliamps in 1 amp.
The easiest way, and probably the cheapest by the time you're done, is to buy an alternator conversion kit. Because 1967 is the first year of the 12v system, IF your car was 12v from the factory (look in the driver's doorjamb for a "12v" sticker) you won't have to change the radio, bulbs and battery.
can a 12v lawn mower sealed battery be charged with 12v battery charger use on cars
Volts * Amps = Watts 12V * A = 150W A = 150W/12V A = 12.5
Not in parallel NO - unless each charger is twice the voltage required for a single battery. For example if you had 2 x 12V batteries and placed the in series, you would have a 24V battery. If you had two 12v chargers and put then in PARALLEL with each other, you would then have a 12v charger with double the current handling. Of course if the chargers were 24v ones, then it would work fine. if you have 2 x 12v batteries (for example) and wished to charge them with separate chargers (actually quite a good idea), then each charger would be over each battery. So the batteries would be in series, the chargers would also effectively be in series too. Basically another way of looking at it would be two have a 12v battery with a 12v charger to your left and then on the right another 12v battery with a 12v charger on it. Yes you can connect the two together in series. The only slight caveat is that the chargers must be isolated from each other - and not for example a "dual output charger" which simply has an extra pair of leads but a shared charging system. - 12v + - 12v + ---------+-BATTERY---+----------+--BATTERY--+-------- - | |+ - | | + |=CHARGER=| |=CHARGER=| - <------------------------------- 24 v ----------------------------> +
Connect the 12V winch to one battery, assuming the 24V system has two batteries, connected in series.
Anything needing 12V to operate.
12v, 3.3v 5v