its the main switch to turn your headlights on. on the dash to the left of the steering wheel
If the master lighting switch is on in a Lincoln or any other car, the vehicle needs to be examined by an experienced mechanic. It could be something as simple as needing a new switch or there could be problems with the electrical system.
brake light bulb out
A switch in the master bedroom.
A switch in the master bedroom.
a master switch is a switch which is the power to evry thing in the billding or factory
I have a 1996 Mercury Grand Marquise. Where is the interior lighting switch on the door.
It is the terminology given to differentiate the dimmer switch from a three way dimmer switch. It is a replacement for an ordinary lighting load switch when you want to dim the lighting load for aesthetic value.
master swiches
If a single pole switch is wired to be a master switch, the switch would have to be in the on position for any other control devices to operate. Turning the master switch off would eliminate power to all devices (and/or loads) which it was serving. For example, some homes have a switch to control their outside light. If the outside light has a photo eye (the light will only come on at night), the switch is the master switch. Another example would be the breakers in an electrical panel. Each breaker would be the "master switch" for the circuit it protects. The main breaker in the panel would be the "master switch" for the entire home.
3
A clap switch is an electronic device that can be turned off and on by clapping the hands. This type of switch is commonly used in lighting.
In this type of situation, where there is more than one lighting circuit, a lighting contactor would be used. These types of contactors can be obtained in four and five pole configurations. Make sure that the contactor is rated for lighting loads and not motor loads. A normal switch, single pole single throw, would be used to switch the contactors on and off. A single switch could then be used to control as many contactors as you need to operate the lighting circuits.If there is just one lighting circuit, the total circuit amperage must be known, then the switch would be sized to the amperage of the circuit.