They are both types of AC circuit. A single-phase supply is carried on two wires, a live and a neutral. The neutral is different from the live because it is grounded at the supply transformer.
A three-phase normally has three live wires and a neutral, and it can be used for three separate single-phase supplies to adjoining properties for example, with each property connected from one live wire to the neutral.
The three voltages are timed or 'phased' to peak one third of a cycle apart. If each property was drawing an identical current, the sum current in the common neutral sums to zero, and therefore the neutral has no current in it and therefore incurs no power losses. Thus the losses are half what they would be for three separate single-phase supplies each with its own neutral.
If there were three hundred properties instead of three, the current in the three live wires would be nearly equal nearly all the time, and again the current in the common neutral would be near zero.
This system allows power to be transmitted over distance using half the mass of wire.
The standard nominal voltage in Canada for a single-phase residential supply is 240/120-V split-phase supply.
Phase to phase, two wire is classed as single phase. If the voltage from the phase to phase match the device's operating voltage, then connecting the device will allow it to operate.
In the US the voltage is about 220 volts. This voltage is based upon the average voltage of the AC sine wave. It can peak as high as 240 volts or as low as 210 volts. So these different voltages are actually referring to an average 220 volt system.
A single straight line is used to represent a single covalent bond between atoms. As examples,C-H is a carbon bonded to a hydrogen by a single covalent bond. S-O is a sulfur bonded to an oxygen by a single covalent bond.
single stranded RNA
The single phase voltage in India is 230v when we check with the phase and the nutral single line
Ac voltage
Digital devices deal with logic levels, you need a steady (DC) voltage to represent a 1 and another steady voltage to represent a 0. Power is used each time a level changes. AC is constantly changing, and is defined by a peak voltage and a frequency, so a single voltage reading is meaningless. For example a house outlet could be 140V one time then -30V, etc (120V outlet swings between -170V and 170V)
Three-phase voltage in Germany is 400V, single-phase voltage is 230V.
235.6 volts.
The single phase voltage in India is 230v when we check with the phase and the nutral single line
The dropper diode voltage regulator is a type of voltage regulator. It is comprised of a single diode that serves as the voltage regulating device.
A CPU that requires one voltage for both internal and I/O operations.
The same as in single phase with the same RMS voltage.
The single dot in braille represents 'A'
240v
yes you can