Small screwsriver pop the metal speaker covers off..easy access to speakers from there
I place them under the suspension cradle (the large metal framework).
Most of it looks like metal pipes.
Cut it out and weld in new steel.
You will probably have to replace the upper and lower ball joints. Dodge does not put grease fittings on these from the factory, because of this they wear quickly and the squeaking you here is the metal to metal in the ball joint when there is motion in the front end of the truck.
The radiator is located under the hood, directly in front of the engine fan. It is not to be confused with the air conditioning condenser which, if equipped, is directly in front of the radiator between the radiator and the grille. These two parts look very similar, but the radiator will have large rubber hoses (one at the top driver side corner with a metal radiator cap and another at the bottom pass. side corner) connecting it to the engine.
remove front wheels, inner guards and bumper. Then remove air box's, loosen metal bumper support get right air duct out, remove all bolts and fit two longer ones in so it does not drop down. You can now get to condenser pipes and mounting bolts
The points are in parallel with the condenser. Both are connected to ground on one side (screwed to something metal). The other side connects to the coil.
Watch out for the front frame just behind the bumper. Plus the bumper and front sheet metal to frame mounting brackets. The boxed in front frame section tends to rust out bad.
front passenger side of intake manifold ( it screws into the metal of the manifold). under the air filter box.
unplug the bulb, then remove the metal clips on front of headlight that secure it to the grill. pull the headlight straight out of the front of the grill. This is the best way to change the bulb as well.
Dodge it...