The hood prop rod
The connecting rod bolt torque for Nissan TD 27 is what holds up the hood. It comes in handy when trying to do something under the hood.
Just under the emergency brake, is the hood release. Pull the release, which pops the hood. Get out of the van and walk around front. In the front center of the hood is a latch, you can feel with your fingers. lift the latch up, while lifting the hood. There is a rod located on the left side that holds up the hood. I hope this helps, good luck.
The top of your head does usually.
When you open the Drivers side door, look down and you will see a lever with the picture of a car with its hood up. Once you pull the lever the hood will slightly pop up, after that go to the front of the car and between the hood and the grille there will be a lever. Pull that lever and pull the hood up once the lever is as high as it can go. Now that your hood is open, put the hood support rod into its hole. Now you have an open hood.
Hood prop or gas struts or springs.
There should be a black support rod laying flat in front of the radiator. It pivots on the right (as you face the engine). Position it upright and into a hole in hood.
1or 2 holds up the hood or if wagon rear glass
On a Classic Bug you don't need one. There's a spring in the middle of the hood (the one over the engine) that holds it up for you, and the trunk lid has hinges with springs in them.
His name is Atlas
There are hood tools. But if it is stuck, you might have to jack her up, remove the wheel, and back fender skirt. Then the fun begins. If it is broken at the hood connection, you will have to bend a metal rod to reach, and pull.
Some fishing chairs include a hook which holds up you fishing rod for you. This allows you to relax and enjoy a drink while fishing yet maintain your line in the water.
a hookie