Want this question answered?
It will be in the bottom of the oil pan.
Standing in the front of the engine, It will be on the top right rear of the engine block.
A Chevy Silverado truck which is experiencing high oil pressure has a defective oil pump or blockage within the oil passages. This can lead to engine failure as components will not receive adequate lucubration.
6Qts. with a new filter.
The process to change the pressure sensor is the same for any engine in the 2005 Silverado, but the location may change between engine types. The sensor should be close to the oil filter. Remove the sensor wire, then screw the sensor out. Screw a new sensor in, then reconnect the wire.
40 to 45 LBS. @ 2000 RPMs
Right behind the distributor and it is tough to get to.
Oil leak and overheating?
the oil pressure swith should be down never the oil filter it screws into the neck that the oil filter is attached in a 4.3lt v-6 that is
There is no inertia switch on the Chevy truck it runs from the ecm , oil pressure switch and relay.
40 on idle
It is screewed into the top of the engine block right behind the distributor.