0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type oil 1977 gl1000 goldwing?
10w40 is good. Check out Motul.
Where is the oil pressure and water temp sensor on the 454 engine?
On my '76 454, the oil pressure gauge hooks to a female threaded hole located directly above the oil filter. an oil line runs from here directly to your oil pressure gage. The coolant temp sensor is located in the middle of the cylinder head usually on the drivers side.
Will the carbs from a GL1100 fit on a 1979 GL1000?
Yes, but expect tuning issues. Change the cams as well. ignition timing? all have to be considered. not a bolt on solution. Go to Randal Randakk's GL1000 site he is the expert on carburetors for all GL1000 http://www.randakks.com/
Your Honda GL1000 starts cold but engine dies after few minutes No spark until engine cools down ballast resistor ok Fuel to carbs ok Oil pressure indicator light goes out before engine crancs?
needs new coil or cdi box
How many 1975 Honda gl1000 were made?
13,000
Why is oil light on 2004 pt cruiser?
Low oil pressure or failed oil pressure switch.Low oil pressure or failed oil pressure switch.
Why would oil pressure gauge flicker?
Low oil pressure or a defective oil pressure sending unit.Low oil pressure or a defective oil pressure sending unit.
How many 1976 Honda gl1000 ltd were made?
2,000
Design a 66 inches dia buried pipe with working pressure 76 psi?
The pressure is important but so is the substance which the pipe is to carry. Is the substance carried at 76 psi or is that the external pressure
Why does the oil light flicker at idle on your 2001 Chrysler Sebring with a 2.7 engine?
Low oil, low oil pressure, failed oil pressure sensor.Low oil, low oil pressure, failed oil pressure sensor.
Why does your oil light keep coming on your 2002 pt cruiser?
Oil pressure is low, oil pressure sensor has failedOil pressure is low, oil pressure sensor has failed
Low oil but your oil pressure gauge indicates normal pressure?
Oil level and oil pressure are different. You don't need to have full oil to get normal pressure.
