Parralel parking with a miget.
The top of the strut rod should be flattened slightly into a rectangular shape. It should be enough that you can take a crescent wrench and hold the flattened part with it. Use an open end wrench for the nut, putting it on first, then the crescent. Turn them opposite directions to loosen the nut.
To remove the struts from the front of a 2002 Bravada, first, safely lift and support the vehicle on jack stands. Remove the wheel and brake components to access the strut assembly. Disconnect the strut from the steering knuckle using a socket wrench, and then remove the upper strut mounting bolts located in the engine bay. Finally, pull the strut assembly out from its mount and repeat for the opposite side.
pressure of a strut
no
You will need to compress the strut spring with a spring compressor. When the strut spring is compressed remove the strut retaining bolts. There is a strut retaining bolt on the top and the bottom of the strut assembly. Reverse the process to install the new strut.
strut as in English
donkeys trot not strut.
Begin by compressing the strut spring with a spring compressor. Be very careful as the strut spring will be under hundreds of pounds of pressure. Remove the strut retaining bolts. Reverse the process to install your new strut.
jack up car, remove wheel, may need a pry bar, remove 2 bottom bolts at bottom of strut. go into trunk area & find top of strut mount and remove the 3 or 4 nuts securing the top. push down hub assembly & pry outward, pull strut down and out. installation is opposite of removal.
no cats do not strut, they may look it but it may be a sore leg or something like that
Take the strut from the left and use this
Milano Strut was created in 1978-12.