0
What is the part between the water pump and the block called on a 1987 Ford Bronco with a 302 engine?
Wiki User
∙ 18y ago
timing cover, it bolts to the block and covers the timing chain and gears, then the water pump bolts to it.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How many fuel pumps does a 1978 bronco 400 have?
One, mounted on the engine block.
Is there a fuse relay for 1978 ford bronco fuel pump?
No, it is a manual fuel pump mounted on the engine block.
Where is the temperature sender on a 1990 Bronco with the 302 ci engine?
Should be on the top of the block near the water pump. I think it is a two wire pair that screws into the block.
Timing chain cover location ford bronco 5.8 engine?
Timing chain cover is where the water pump hooks to on the very front of the engine block.
Where can you find the oil pressure sensor on a 1990 Ford Bronco II 2.9L V6?
Front left side of the engine below the cylinder head in the engine block.
What determines the difference between a small block engine and a large block engine?
The bore and stroke.
Where is the head gasket on a 2003 Venture?
Sandwiched between the head/heads and the engine block.Sandwiched between the head/heads and the engine block.
What is a complete engine assembly called?
A long block. A short block would be without the heads.
Where is the oil sending unit on a full sized 1988 Ford Bronco?
It is on the driver side of the engine block next to the power steering pump.
Will a 1989 ford bronco transmission fit a 1991 ford bronco?
Make sure that the the two top bolts from the transmission match your engine block before attempting to install. Some are spread out and won;t match.
Location of Oil Pressure Sending Unit on 1979 400m in Ford Bronco?
Top center of engine at rear of block behind intake manifold.
What is the lower half of 1996 318i bmw engine called?
The engine block, some refer to this as a short block. a short block refers to the block, crank shaft and pistons.
