fuel sender unit
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
Torque as follows 53-63 ft/lbs. in 3 steps
The torque specs and pattern on the head bolts for a 1991 Toyota pickup with a 3.0 EFI is 50 foot pounds per bolt. The pattern is 4,5,6,3,7,2,8,1 with 1 being at the front of the engine.
Remove 3 bolts, remove shock, insert shock, compress shock, replace bolts
The torque specs and pattern on the head bolts of a 1991 Toyota pickup with a 3.0 engine are 5, 4, 6, 3, 2, 7, 1, and 8. This sequence is started from the center of the head and requires 75 foot pounds of torque on each bolt.
the cluth fan bolts right up to the water pump mounted on the block
a really long extension works really good if you took the transfer case off allready.
The fuel filter on a Toyota pickup having a 22re engine is located on the left side, directly under the intake manifold. It is held on by two 12mm bolts. If you look under the truck, you will see the filter to the left of the oil filter.
Yes because you have to take the bolts out of the transmission and slide back enough to replace your clutch.
2 bolts
Torque Value For 1987 R22, Per Haynes Manual - 58 ft lbs.
The front bumper bolts directly to the factory mounts on the frame. You need to remove four bolts, two on each side. Use a 14 mm socket wrench. The bolts are parallel to the ground and perpendicular to the center of the vehicle.