If turning the pump off and back on restores water flow, the problem is not that your well has gone dry. the problem is in your pump.
AnswerIf this is a down-well water pump, there may be poor connections in the wiring from the surface to the pump, which reconnect when the pump jerks when it turns on and off. AnswerIf turning off the pump and restarting works then it may be as simple as sediments clogging the in-take.ANS 4 - The most likely cause is that your well's replenishment time is getting longer. -ie, it's taking longer to come back to the original static water level. This is a very common problem, especially if more or larger wells have been drilled in your aquifer recently.
Sometimes this can be fixed simply by lowering your pump a few feet if that's possible.( I used to do that a lot in my years as a well tech.) If that's not possible, the well must be deepened.
more than like you have a serious electrical problem.
If it only stalls in corners this indicates a serious electrical problem that will only get worse
how much does an electrical motor of 380V AND 150HP losses of his effeciency after turning on
There may be a problem with your electrical wiring that is preventing your hazard lights from turning off. You should take your car to a Toyota mechanic.
Its a common problem with the 95 to 99 Chevy tahoes. Theres a sensor by the steering colunm that goes bad. go to this forum with all the info. www.automotivehelper.com/topic317059.htm
Physically has a turning problem ? Try your spare key and still has the problem? Replace the ignition switch.
from mechanical to electrical
Turning on a lamp
More detail is needed here, does it make a clicking noise, is there any feeling at all when turning key, do other electrical items work, etc.More detail is needed here, does it make a clicking noise, is there any feeling at all when turning key, do other electrical items work, etc.
Turning mechanical energy into electrical energy The alternator works by turning mechanical energy into electrical energy. When your engine is on, it powers a drive belt that rests on a pulley attached to the alternator. The pulley turns the alternator's rotor shaft, which spins a set of magnets around a coil.
electrical energy turning into macanic energy:)
Centrifugal force is a problem when turning at fast speeds.