Check master cylinder for fluid level
Check around all wheels for a fluid leak or bad wheel cylinder
The reason you can pump brake up without engine running is that you are emptying the vacuum reservoir and no longer have power (vacuum) assist
If this problem occurs, then it means that there is a problem with your car. You can get the brake line fixed by visiting a technician.
They wouldn't. You have a problem, and it's hazardous to your health.
Try bleeding your brakes. If there is air in the system it can give a spongy feeling to your brake pedal and require you to pump your brakes and/or put your brake pedal to the floor.
The best way to tell when you need brakes is by squeaking, when the brakes are rubbing against the metal, when your brake pedal goes all the way to the floor and when you are running out of break fluid.
I would suspect the Master Cylinder if defective. I had the same problem with my 1978. I replaced the combination valve and it solved the problem after bleeding.
Not really an answer, but another question... did you bleed the brakes after you changed them? I remember that is a critical step, NOT to be missed when working on the brakes. Hope this helps.
No
you either need to bleed your brakes, add fluid or get a master cylinder darrellshandyman@live.com
You either got the wrong master cylinder or you haven't actually bled all the air out of the system.
Vacuum booster is working--When vehicle off there is no vacuum assist (for power brakes) When vehicle is on vacuum is present Brake pedal going to floor is another problem--no fluid in master cylinder? Leak in system? Brakes not adjusted properly?
Caliper slides frozen? Rear drum brakes? May need to be adjusted
you either need a new brake master cylinder or your brakes need to be bled