Want this question answered?
its recommended you replace the gasket when the head is removed, but if you don't and it does go wrong after refitting you will be doing the job twice for the sake of a few quid, also you should replace the timing belt when refitting,
Anatomic procedures involve correcting the injury or removing the cause of pain.
Thermostat is inside a metal cylinder on the left side of the engine. Just undo the top. Removing it is difficult as it is a tight squeeze out. Installation takes less than 30 minutes.
Most cam sensors are attached with a single bolt. just a matter of locating the sensor, removing the wire to it then unbolting it. Refitting is the reverse of the above.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
what are the procedure of removing abandoned vehicle from your property? Try calling a tow truck- they tend to work good..
removing gas tank for cleaning
You can change the ignition cylinder on your 1999 Mercury Mystique by removing the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness.
The oil on a 2012 Mercedes E550 is changed by removing the drain plug under the engine, draining the oil, and removing the oil filter. The plugs is then reinstalled, a new filter put in place, and the oil filled to the correct level.
Begin by removing the hose from your power steering cylinder. Remove the power steering cylinder retaining bolts. The power steering cylinder will come off.
The power brake booster on a 95 Chevy Blazer is replaced by draining and removing the master cylinder, unbolting the booster, and removing it from the vehicle. A new cylinder is then put in its place and bolted on.
It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.