0
What is the proper plug wire sequence on the distributor cap for a 1969 Pontiac 8 cylinder 400?
Wiki User
∙ 15y ago
1-8-4-3-6-5-7-2 Distributor rotates counter clockwise
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the proper plug wire sequence on the distributor cap for a 1999 Dodge Durango 8 cylinder?
Look on top of the intake manifold for the firing order. Then make sure they are in the right order at the distributor.
What is the proper spark plug gap on a 1986 Pontiac Firebird?
6 cylinder=.045 8 cylinder=.045
What is the proper plug wire sequence on the distributor cap for a 1994 dodge Dakota magnum v6?
The wire sequence on the distributor cap just goes 1 thru 6, clockwise, starting from the number one position (which should be marked either on the cap or distributor).
What is the proper sequence from the spark plugs to the distributor on a 1978 Ford F100 300?
1 - 5 - 3 - 6 - 2 - 4 The distributor rotor turns CLOCKWISE
What is the proper spark plug wiring sequence for a 1993 Honda accord lx?
The firing order is 1,3,4,2. The number one is the one closest to the drivers side tire. There is usually a mark, sometimes an A or A1, on the top of the distributor cap indicating the number one cylinder.
What is the proper sequence on the distributor cap for a 1990 ford mustang v8?
1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 The distributor rotor turns COUNTERCLOCKWISE The marked # 1 position on the distributor cap faces to the REAR and slightly towards the drivers side The engine cylinder / spark plug locations are numbered : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front
What hole on the dist is 1?
As you face the engine the first spark plug wire on your left is connected tot he first cylinder. Trace it back to the distributor and you will have the proper hole. If you have no wires connected then it is usually positioned at about 1 oclock as you face the distributor. (assuming the distributor is properly positioned)
What is the proper placement of plug wires on distributor for a 1973 Chevy 400 small block?
1 is where the rotor is when number 1 cylinder is firing. Then clockwise from 1, 8,4,3,6,5,7,2.
What is the sequence of events associated with the proper functioning of the pacemaker?
What is the sequence of events associated with the proper functioning of the pacemaker?
Where is distributor located on 1993 Buick LaSabre?
The ignition coil pack is bolted to the cylinder head left side when facing the car from front bumper. It's on the cylinder head closest to the front bumper as well. This vehicle does not have an actual distributor because there are 3 ignition coils that fire at the proper time (if you're interested it's called the waste-spark method). The multiple ignition coils eliminate the need for a distributor.
What are the proper timing procedures for a 1993 4.3 liter?
you need to bring cylinder 1 piston up to top dead center on compression stroke then turning the oil pump drive shaft so the distributor rotor faces #1 on the distributor cap.
What are the head bolt torque specs for a 1999 Pontiac Grand Am 2.4 4cylender?
HEAD BOLT TORQUE For your 1999 PONTIAC GRAND AM: HEAD BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE SEQUENCE --------- | 6 2 3 7 | | 5 1 4 8 | --------- STEP 1: TORQUE IN SEQUENCE TO 33 FT/LBS STEP 2: TURN AN ADDITIONAL 90 DEGREES RECHECK FINAL TORQUE IN SEQUENCE *** CAUTION *** ENGINE USES TORQUE TO YIELD HEAD BOLTS (TTY) THAT PERMANENTLY STRETCH DURING THE INITIAL INSTALLATION. NEW HEAD BOLTS MUST BE USED WHEN CYLINDER HEAD IS REPLACED OR RE-INSTALLED TO OBTAIN PROPER TORQUE. ALWAYS COAT BOLT THREADS WITH THE PROPER SEALANT.
