Hydraulic hoses are used to drive the fan.
i have a 1989 chevy blazer gos in 4x4 drive but front wheels are not pulling wat do i do about that
Perhaps coupling and clamps, but always better to replace. A shop fitted with the proper equipment to make hydraulic hoses can.
which hoses???????? you need to be more presice
I need a diagram for the 1991 Chevy blazer to see where the 3 hoses go to coming off the transfer case.
Hydraulic pipes and hoses made ​​of fiber-reinforced plastic and pressure-resistant. The site is connected to the screw press. Hydraulic pipes and hoses are very expensive.
Hydraulic fittings are components that enables connecting hoses and steel tube between the various components (pumps, valves, hydraulic motors, etc.) in a hydraulic system.
Really need more info. If your blazer is two wheel drive the oil filter is located on the left (drivers side) towards the rear of the motor next to the oil pan. If it is 4 wheel drive go to the location described above and follow the hoses to a satelite filter assembly.
In a normal hydraulic power pack you get a pump and motor to power it, the hoses, hydraulic fluid to fill it with as well as the rams to power whatever it is that you are using to connect to the pump and lines.
The hydraulic system works is dangerous. If the holes are pressure hoses transmission oilis sprayed with high pressure and this is very dangerous.
This specification is for hydraulic hoses and the various part numbers describe the construction of the hose including material and how many layers of what kind of reinforcement.
by friction and absorbing outside heat
Shock and vibration in hydraulic oil transfer hoses.
Power steering hoses are under pressure and have to be repaired with specialty tools. The hose either has to be repaired by a hydraulic hose company or replaced entirely.
Take a good look at the hoses and fittings. They are three different sizes. They can only fit correctly one way.
Replace with reinforced hoses Check radiator cap for proper pressure
Oil supply sump, pump, relief valve, control block, hydraulic motor (cylinder), pressure gauges, piping or hoses. And there may be multiples of each in a complex system.
Remove the heater hoses from the heater core at the firewall and hook them together. In order to connect to two same diameter hoses together, get a 5 or 6 inch piece of pipe which is the same diameter as the heater core tubes from which the hoses were removed. Install the pipe halfway into one hose and secure tightly with a worm-drive hose clamp. Then once secure, do the same with the other hose.j3h.
The main function of brake hoses is to carry brake fluid through the hydraulic brake system in an automobile. Brake hoses are also used measure a vehicle's horsepower.
I just put a new transmission and have 3 hoses coming off the transfer case and need to know where to hook them to.
Check for kinked hydraulic lines (hoses or pipes)Bleed all lines and cylinders of trapped air.Check hydraulic oil level.Change hydraulic filter.Have oil pump rebuilt, or replaced with new.
The connection between the power steering to the vacuum hoses is called the hydraulic brake booster. It supplies the vehicle with fluid pressure from the power steering down to the hoses.Ê
bottom of fan assy. look for 2 hydraulic hoses going to the fan...