answersLogoWhite

0


Best Answer

.035

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the proper spark plug gap for a 1972 Oldsmobile cutlass 350 V8 with a 4 barrel carburetor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause a 1998 Oldsmobile cutlass to shake and mist?

you have to be more specific for a proper answer... at what speed does it shake?.... 40mph> ? what do you mean mist?


What order does the distributor caps have to be in a 93 Oldsmobile cutlass sierra?

What do you mean by what order. Go here pick the proper engine and you will get your answer. http://autorepair.about.com/library/firing_orders/bl-oldsmobile-firing-93.htm


What is the proper tire pressure for Oldsmobile cutlass 97?

On the back driver side door it says front 26, back 29--Or the other way around. I was surprised that they aren't 32.


97 Oldsmobile cutlass supreme tighten the belt tensinor?

Belt tensioner is not adjustable. Assembly is spring loaded, spring can loose tension. If belt stretches or is too long (wrong part) then .... (There are marks on assembly to indicate proper tension.)


What is proper tire balance for a 95 Cutlass?

32lbs each tire is a good bet.


Will 24 inch rims fit on a 1984 cutlass supreme?

with the proper lift and tires


Why would the turn signal flasher in '90 Oldsmobile Cutlass Ciera still not work after being replaced?

do you mean you replaced the bulb? are the flashers out on both sides of the vehicle? did you check both front and back? do the lights on the dash do nothing or come on and stay on? you need to provide this information for a proper diagnosis


What is the purpose of a carburetor?

It mixes fuel and air in the proper proportions to be burned in an internal combustion engine.


Where can you find the Knock sensor on a 1991 Oldsmobile cutlass calais?

If it is a quad 4, the knock sensor is on the firewall side of the engine, at the transmission end of the engine, just below the exhaust manifold. It has a single lead and is about 2" in diameter and 1-1/2" high. Use a proper fitting socket or wrench to unscrew it.


Why 1992 Oldsmobile will not shift out of park?

A 1992 Oldsmobile may not shift out of park because the transmission is stuck. Check to transmission fluid to ensure it is at the proper level.


What makes a 1996 Oldsmobile cutlass supreme run hot?

Could be a few things, plugged radiator, bad thermostat, bad waterpump, electric fan not kicking on when it's supposed to or the fan itself could be bad, also the cooling system could need flushed and a proper 50/50 mix put back in.


With the carburetor set screw closed What is the proper amount of turns of open to begin adjustment of carburetor on your Ryobi mod -ry 30544line trimmer?

1-1/4 to 1-1/2 turns is standard.