Are you talking about the "idler pulley"? They are quite simple to change. Loosen the serpentine belt by using a socket on the center of the tensioner pulley, slide the belt off the idler pulley, use a socket to pull the center bolt of the idler pulley and replace the pulley with a new one.
no there is not.
It is the small pulley with a nut in the middle on the pulley assembly!
Remove the alternator belt by loosening the tensioner pulley. Remove the wiring from the alternator. Remove the retaining bolts to the alternator. Reverse the process to install the new alternator.
Check the alternator if that don't do it change the battery
It is built in to the alternator.
How do you change a fuel pump on 94 Chevy caprice ls
how do you change the alternator on a chevy 2006 hhr
How do you change the heater coil in a 1994 chevy caprice?
triple diodes in alternator are bad
how do i change the alternator in my 1999 Chevy prism, picture with instructions will help.
The serpentine belt on a 92 Chevy Caprice Classic is changed by loosening the tensioner pulley and pulling the belt off. A new belt can then be put in place and the tension restored.
Defective voltage regulator. It may be built into the alternator.
To change the alternator in a 1985 Chevy Celebrity; 1. Disconnect the battery ground. Use protective gloves. 2. Loosen the belt adjuster bolt and the main mounting bolt. Move the alternator to loosen the drive belt, then remove the drive belt from the alternator pulley. 3. Disconnect the wires from the alternator. 4. Remove the bolts and lift the alternator from its mount. Reverse the instructions to reinstall the alternator.
The alternator should be on the front of the motor with a belt on the pulley and wires connected to the back of it that can be removed.
No.... You need to change the whole back tail piece
can you change the alternator belt in a 1998 Chevy metro from under the car.
It's not charging the battery. Check the alternator.
probably a TH700, but take a look underneath
Also in order to loosen the serpentine belt you have to use a wrench or something and turn on the bottom pulley....easy remove the serpentine belt for the fan area and remove the two bolts that hold the alternator down and unclip the wiring harness
You have to loosen the tension on the belt by loosen the nut normally found on the pulley located by the motorblock, manifold or even by the alternator pulley it's self.
For 2.2L 4 cylinder push rod engine. Turn bolt on pulley tensioner clockwise with 15mm wrench. Remove pulley belt. Disconnect battery. Remover main electrical connector from alternator. Remove one wire electrical connector from alternator. Remove 3 or 4 bolts from alternator. Reverse order for installation.
right under the alternator, just follow the belt down.
U need to purchase a Chevy power steering pump removal/install tool. its a small pulley type tool and will take the pulley off of the pump. once its off, there should be 3 bolts that hold the pump in place.
How to change a heater cord for a 93 chevolete caprice
The main pulley on which the serpentine belt goes on in a 1997 Chevy Lumina LTZ is the crankshaft pulley. The crankshaft pulley plays a role in the wheels turning and powering the alternator and power steering pump.