Strange, do you go to Stanbridge? Each time I Google answers for my homework, someone always asks these same exact questions on this website.
Suffice to say, I do not have the answer, as I am looking for it myself.
It is 100000 Hertz.
The purpose of a time card clock is to accurately know hourly employee's time in the office. This system is being replaced by employees clocking in on the computer.
The "clc" command is used to clear the command window in Matlab.
So you can read the time? (I don't know, that's a strange question)!
Dynamic frequency scaling
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
The command is: clock rate 56000 So it will appear on the command line interface as: Router(config-if)# clock rate 56000 Reference: Networking by Jeffrey Beasley Chapter 6 page 216.
When the interface is functioning as a DCE device
The interface is configured as a DCE device.
Clock rate.
Data Generating Capability of a Device is called Clock Rate. If the clock rate is high, the processing will be slow down. If the clock rate is low, the processing will be high.
The purpose of all clocks (e.g. mechanical clock, water clock, electronic clock, atomic clock) is to measure the passage of time.
"time" command.
Special Purpose Command ended in 2009.
Special Purpose Command was created in 2002.
If you are in search of learning the purpose of the AS command in SQL, there are a few resources that are available to you. One resource that can explain the purpose of the AS command in SQL is Wikipedia.
Big Ben is a chiming clock and has the same purpose as any other clock.