Want this question answered?
there should be a Honda stamp on the inside center of the rotor
How do you change the front and rear brake pads on a 2000 Honda Civic Si?
it could be anything from a bearing to the splash shield on the brake rotors.
The minimum brake rotor thickness for the front and back rotors on a 1992 Honda Accord is 21mm. Rotors which are below this thickness will not offer adequate or reliable braking.
You have to remeove the disc brake calipers first by removing the 17 mm bolts connecting them to the strut , the there are 2 screws on the front when they are off the rotors are ready to be removed, reassemble in reverse order
You will find that the front brake rotors are located behind the front of your wheel spindle, (behind your wheel and brakes). There you will see the rotors.
They sell front brake rotors at Auto Zone, Pep Boys, Goodyear, Firestone and their are other places that sells front brake rotors such as Sears, Walmart and Sam's.
Begin by removing the tire and wheel from your 1993 Honda Civic. Remove the brake assembly and the brake rotor. Remove the axle retaining bolts. The axle will come off.
To change front brake pads on a 2002 Honda Civic raise the vehicle and safely prop it up. Remove the front wheels and caliper. Take off the old pads. Decompress the caliper piston and insert the new pads.
Change front brake rotors on a 1998 Hyundai Accent?
I just had a full brake job done (front and rear pads, plus new front rotors) for my 2004 Honda Pilot, the total for parts and labor was around $600. Labor rate was $85/hr so if you find a cheaper shop it may run you a little less (figure 3 hours of labor).
The 1995 Honda Civic speed sensor is located on the front passenger wheel. The speed sensor will be found on the inside of the brake rotor.