It is a T30 Torx. A T27 will work, but is slightly loose in the nut. The bulb for stop and turn signal is 3157. Two bolts to remove to get access to the bulbs.
The piston in the rear caliper on the 2008 Grand Caravan is the "screw in" type. A special tool is required to do the job.
screw it clockwise
Large pipe wrech...unscrew and screw new one on!
There is no adjustment screw, idle is automatically controlled by the pcm.
There isn't one. The idle is computer controlled and is not adjustable.
A key
Using an angle drill, drill a small hole in the sensor. Thread a screw in the hole, and use it to pull the sensor out.
If the screw is coming down from the top, you will need to remove the dash and HVAC housing.
To change the flasher in the front, remove the circular plastic cover in the wheel well by rotating and you can reach the bulb assembly and unscrew the bulb. if it is in the rear you just undo the one screw and it slides off. if in the front there are a few bolts holding it on under the hood and behind the light assembly.
Remove the four screws holding the grill and then the screw on the side of the turn signal
Under hood just aft of the light housing you will see a few holes. It appears that it would not be anything but if you use a flashlight you will notice a torqux adjusting screw located about 7" down behind the light housing in one of the holes. Its either a T-20 or T-25 star bit. These adjust the light beam. You must first loosen the light assemble first to get the adjustment screws to work then re-tighten the light.
input and output speed sensors are located on the side of the transmission case across from each other. they are plastic and screw into the trans on 3.3l and 3.8l 3.0 may have the sensor where the pass side axle goes into the tranny