Using an angle drill, drill a small hole in the sensor. Thread a screw in the hole, and use it to pull the sensor out.
You must remove the 3 bolts on the opper part of the headlight housing and then remove the entire housing. You can then reach the bulb connection
The crankshaft comes out of the bottom of the engine with the engine out of the car. Get a manual on your car from AUTOBOOKSONLINE.COM. sorry, i asked the wrong question, i just need to know how to remove the pully of crankshaft, Thanks!
it is the sensor that sticks in the bell housing between the eng and trans held in by a 10mm bolt top back side of the trans remove the snorkle and air box to see it
If the screw is coming down from the top, you will need to remove the dash and HVAC housing.
Follow the upper radiator hose to where it meets the engine. Remove the two bolts of the thermostat housing and remove and replace the thermostat.
for a 1994 Grand Caravan (probably like the 1995) see: How do you replace the headlight assembly located on a 1994 Dodge Caravan? for a 1994 Grand Caravan (probably like the 1995) see: How do you replace the headlight assembly located on a 1994 Dodge Caravan?
top of bell housing on passenger side . remove inner plastic fender for easy access
Remove the obvious bolts and then give her a pull and wiggle. The box sits in rubber brakcets that tend to hold.
TAke the bolts soose that hold it on. It is an assembly.
You have to remove the drivebelt accessories and then remove the timing covers and take out the timing belt or chain. Basically you have to tear the side of the engine apart to get it out. It's a good day or two of work.
how to remove crankshaft position sensor from 91 Buick Regal
It taps into your bell housing, behind where the motor meets the tranny, it is right above your cross member, you can remove the cross member and get to it very easily, you do not have to remove it to replace it though