24 mm
24 mm
24 mm
Above the oil filter, where it screws on. You'll need a special socket to remove/install a new one.
I have used 3" water pump pliers on almost every car I've ever had. Never seen an oil filter that requires a socket.
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
remove the center threads were the oil filter screws on it takes a socket to take off some an a Allen wrench on others. remove the center threads were the oil filter screws on it takes a socket to take off some an a Allen wrench on others. remove the center threads were the oil filter screws on it takes a socket to take off some an a Allen wrench on others.
9mm
You will need a 35 mm socket.
You will need a 5/8 socket.
You'll need a 5/8" socket.
9MM
A 11/16 socket is needed to remove the 1984 Chevrolet pickup front axle hub assembly. The socket should be a five-point socket.
The fuel filter is located at the rear underside held in by a bracket a 10mm spanner or socket will be needed to remove the bracket. The fuel pipes are normally push fit but be careful they can easily be damaged if forced.
The correct size Torx bit is a T-55.