I have used 3" water pump pliers on almost every car I've ever had. Never seen an oil filter that requires a socket.
24 mm24 mm
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
Oil Filter is two types.First is Spin On disposable style and second is Canister with Element.Disposable type needs a Strap Wrench tool remove it. Installation is by hand and about 1/4 turn beyond seated.The Canister with Element style needs a 24mm socket to remove the filter head.Located on the drivers side (Left.) towards the bell housing or rear of the engine.
remove the center threads were the oil filter screws on it takes a socket to take off some an a Allen wrench on others. remove the center threads were the oil filter screws on it takes a socket to take off some an a Allen wrench on others. remove the center threads were the oil filter screws on it takes a socket to take off some an a Allen wrench on others.
9mm
You will need a 5/8 socket.
You will need a 35 mm socket.
You'll need a 5/8" socket.
9MM
A 11/16 socket is needed to remove the 1984 Chevrolet pickup front axle hub assembly. The socket should be a five-point socket.
The fuel filter is located at the rear underside held in by a bracket a 10mm spanner or socket will be needed to remove the bracket. The fuel pipes are normally push fit but be careful they can easily be damaged if forced.
actually he asked for the 1997 catera which has no dip stick it is a sealed system. you cannot check it I have a 1998 Catera and oil filter is on the underside of the motor and can be accesses on the drivers side, under the car. I think the transmission is maintenance free unless you see a leak. If you have a leak you have to pull the pan to refill. The oil filter is locater in a small houseing on the rear lower side of the engine on the drivers side. It is nearlly directlly above the crank position sensor. The filter is held in by a black plastic screw on cover that will be easilly seen when under the car and on the driver's side. It will take......a 32MM wreench or socket to remove the the cover. Do NOT try to use anythin other than the appropriate socket or wrench for yu may destroy the outer part of the cap.