.44 to .45 inch
The PCV is located on the driver's side of the engine. It is at the same level as the spark plugs, in the middle of the engine. It is not seated in the oil cover. It is seated in the oil diverter.
Take it to jasper they rebuild any motor.
On my 1993 Ranger, 2.3L, it is a bolt between the two front wheels underneth the engine. Should be pretty easy to spot. The oil filter is on the drivers side of the engine, towards the bottom. Also easy to spot.
bad crank shaft position sensor
The engine oil capacity for the 1992 2.3L is 5 quarts (includes filter).
egr valve location on a 1997 ford ranger 23l
http://www.carburetorfactory.com/expvw28.html Dax Sosa El Salvador Vw Parati Gls 1988
yes
23L 4cylinder motors dont have distributors the cylinders on the block are numbered (front to back) 1234 and the firing order is 1-3-2-4 Correct Firing Order: Correct firing order is 1-3-4-2; Haynes Manual #36071, 1993-2005 Ford Ranger Pick-ups
they stems from the intake manafold then run in several places
Here you go: Copy & paste into your browser: http://autorepair.about.com/library/firing_orders/bl-fo-7923.htm
The rear axle oil level plug on a Ford 4500 backhoe is located about 2" above the right hand running board near the rear end of the running board. This is 5 or 6" directly behind the transmission level plug and is located on the round access cover plate. If you have a cab, the plate under the seat (4 bolts) will need to be removed in order to replace the level plug unless you can find someone with small fingers to reinstall it for you. Mine took about 23L to fill from empty.