Want this question answered?
to create a mapping of DLCI to Layer 3 addresses that belong to remote peers
0
data link connection identifier (DLCI) is a channel number. Think about is like a gate on a airfield. You being data, that is using a gate to get your destination.
0x0=0
Dlci pvc
So 0x0=0 or undfined
DLCI
Inverse ARP, or it can be done statically
DLCI
0x0
main() { int num=0xABCD; printf("%x\n",num); int rev=0x0; int digit=0x0; while(num!=0x0) { digit=num%0x10; rev = rev*0x10 +digit; num=num/0x10; } printf("%x\n",rev); }
To set the source Data-Link Connection Identifier (DLCI) for use when the Local Management Interface (LMI) is not supported, use the frame-relay local-dlci command in interface configuration mode. To remove the DLCI number, use the noform of this command.