Mostly to drive the steam turbine. Smaller amounts may be used for in house tasks like preheating feed water.
It depends on the type of power plant. Some of the most common is coal (which is used to make steam to create power) one of the least common in the us is nuclear power.
It scavanges oxygen in water systems to prevent corrosion of piping.
steam pipes.
It removes the gases present in the steam,given by heaters.dearater is necessary otherwise the gases in steam will corrode the boiler and also affect the turbine.
1. Can be made in much greater output plants 2. Steam plants can use a variety of fuel sources including nuclear fuel, whilst diesel fuel is more expensive and best reserved for transport use.
We see the wide use of pipe to carry steam and water in a power plant. Insulation is applied where necessary.
To convert the heat of combustion to steam which can be used in an engine.
Heat from the nuclear reaction changes water to steam.
Actually, superheated steam is used in nuclear power plants. It is part of the goal of extracting the most energy possible from the steam cycle.
gland steam cooler is used to cool steam of gland sealing comes from turbine
Steam in nuclear power plants is used to drive turbines for generation of kinetic energy.
In a nuclear power plant, the heat energy released from fission is used to change water into steam. the steam then turns the blades of a turbine to generate electricity.
Heat from the nuclear reaction changes water to steam.
it is steam from water being used as a coolant for the plant.
Electricity and steam. In some locations the steam is used to heat homes and businesses.
Dry Steam Power Plant : generates power directly from the steam from inside the earth.Flash Steam Power Plant : Flash steam plants use waters at temperatures greater than 360F. As this hot water flows up, it is collected in a flash tank where drop in pressure causes the liquid to boil into steam. The steam is then used to run turbines which in turn generate power. The condensed steam is returned to the reservoir.Binary Steam Power Plant : This type of plant uses high temperature geothermal water to heat another liquid which has a lower boiling point than water.
Dry Steam Power Plant : generates power directly from the steam from inside the earth.Flash Steam Power Plant : Flash steam plants use waters at temperatures greater than 360F. As this hot water flows up, it is collected in a flash tank where drop in pressure causes the liquid to boil into steam. The steam is then used to run turbines which in turn generate power. The condensed steam is returned to the reservoir.Binary Steam Power Plant : This type of plant uses high temperature geothermal water to heat another liquid which has a lower boiling point than water.