Chevy S-10
1995-1999 Dodge & Plymouth Neons
Honda Accord LX

What is the step-by-step for replacing a starter on a 1989 Chevy S-10 pickup?

757677

Top Answer
User Avatar
Wiki User
2006-05-07 20:47:35
2006-05-07 20:47:35

first you want to make sure you get both the wires off the back of the starter (this will make it easier later) after that it is 2 bolts holding the starter to the bell housing

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

What year,what motor?? it is a 2002 Chevy avalanche 1500

User Avatar

The starter solenoid is mounted directly on the starter.

User Avatar

The starter solenoid is attached to the starter.

User Avatar

You will have to remove starter, It is behind the starter in the block.

User Avatar

Starter is located on passenger side of engine. On the side of the engine at the bottom.

User Avatar

It is behind the starter, You will have to remove starter to service it,

User Avatar

Follow the positive battery cable from the battery, it will lead you right to the starter.

User Avatar

Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?

User Avatar

It's on the lower right side of the block

User Avatar

It depends on what year and engine you have but, if you follow the positive battery cable from the battery, it will lead you right to the starter.

User Avatar

Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

passenger side by the oil pan in front of the transmission

User Avatar

The starter relay feeds power to the starter when the switch is turned to start. The relay will be mounted either on the fender or on the firewall.

User Avatar

It is mounted on the top of the starter. Just follow the positive cable from the battery and it will be bolted to the selonoid.

User Avatar

did you check your battery and alternator?

User Avatar

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

the starter is located on the passenger side of the engine beneath the exhaust manifold.

User Avatar

undo the wires then take the bolts out then put the new one in.

User Avatar

You should hope so. The other option is a damaged flywheel which is a much larger project than replacing a starter.

User Avatar

Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter

User Avatar

Assuming you are referring to the starter solenoid which is on... the starter. In fact, it's a part of the starter. If the solenoid goes bad just replace the entire starter, the whole thing is probably worn out anyway.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.