Want this question answered?
the timing mark (z) of injection pump and the mark (z) to cam shaft the other markof cam shaf (y) to the idler geer (y) and the (x) mark of idler to main shaft (x) mark
pin the engine on the flywheel. line the timing mark on the cam gear with the timing mark located on the timing cover. the mark on the cover is located at the top and is just a bump formed in the cover.
diagram of timing marks 2c engine toyota
The fuel pam timing mark Scania 400 is on the engine.
A timing mark is usually a white line on the timing belt to sync the firing of cylinders in an engine. You can see this line when the engine is turned off or with a timing light also a strobe light when the engine is running.
The timing mark on a Chevy Inline 6 engine is located on the flywheel. It is a steel ball. The timing needs to?æbe located at 4 degrees BTDC.
On the injection pump gear are timing marks for 3,4 and 6 cylinder engines as the same gear is used in all the engines. To time the pump align the mark with the correct number for the engine with the center of the crank shaft and the center of the injection pump center. Timing should be 10 degrees before TDC on cylinder 1 The injection pump gear has 48 teeth with each tooth representing 7.73 degrees.
2.4l dohc balance shaft timing mark, crankshaft sprocket timing mark,oil pump timing mark and camshaft TWO timing marks 2.4l sohc balance shft timing mark, crankshaft timing mark, oil pump timing mark and ONE camshaft timing mark. it is complicated only that everymark must be bang on, if not the pistons will hit the valves and YOU get to rebuild engine.
timing on an 03 suzuki xl7
Most likely you did not align properly the mark, it causes the engine to have wrong timing as result the engine knocks.
correct yes there is engine timing on a mark 2 golf, as with all cars funnily enough.
There is a TDC mark on the harmonic balancer mark it with a piese of chalk then set this mark to the coresponding gauge (in front of crank position sensor). Hook up a timing light and point it at the harmonic balancer then start engine and turn the distributor until the light falshes at 6 degrees BDC.