Want this question answered?
What is the torque specs on a 2001 ford truck rear end pinion nut..
The General Motors 3.42 rear end pinion?ænut torque specification is 240 pounds. The pinion nut should be torqued in 80 pound intervals.
bad bearings, probably a pinion bearing
I don't believe there is a specific torque specification! Once you install the crush sleeve and tighten the nut to the desired preload on your pinion bearings, your torque will be what it will be.
210ft. lbs.
No
bolt diff cap what is it
If you are asking the question, you need to pay someone to do that. You have to preload the pinion, shim, etc. It isn't a bolt the ring gear in place and torque the pinion and go thing or else you will be making metal shavings and molten metal.
The bolt heads require a 12mm/ 12 point socket.
The only torque you should be concerned with is the torque it takes to rotate the pinion gear alone, 8-14 inch pounds for old bearings, 16-29 in/lbs. for new bearings. The torque it takes to crush the crush collar (tightening the pinion nut) will be above 140 foot lbs. and this will set your tension on the pinion bearings. If you put a new crush collar in you are going to have to remove axles and carrier to get the proper pre-load on the pinion bearings.
caliper bolt size 2007 Honda odysey
yes it does yes it does