0
What is the torque specification for a 2002 Ford Windstar intake manifold insulator bolts?
Wiki User
∙ 18y ago
It is 10 Nm or 89 lb-in for Isolator bolt, plenum bolts, and throttle bolt.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
What is the torque specification for 2006 ford freestyle?
intake manifold
How much would it cost to fix the manifold on a 2003 Ford Windstar?
Need to know if it is the intake manifold or an exhaust manifold and what is wrong with it.
What are torque specs for head gasket and intake manifold for 1999 Pontiac sunfire?
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
What is the torque specification for the lower intake manifold on a 1999 Malibu?
Around 30ft lbs.
Can you drive with one intake manifold runner stuck open on a 1997 Ford Windstar.?
yes you can
What is the torque specification for the lower intake manifold on a 97 3.1L lumina?
10 ft lbs
Where are the insulator bolts located on an 01 ford windstar?
Just in case this is intended to find the notorious isolator bolts, that cause the 171 and 174 trouble codes and intake manifold vacuum leaks... See "Related Questions" below
Where is the intake manifold runner control valve on a 1996 3.8 ford windstar?
attached to the lower intake manifold on the belt side usually little plastic bushings are broken on those
Is there any risk to having a novice remove an upper intake manifold on a 1998 Ford Windstar to get to the fuel injectors Is there a gasket or something that I might ruin?
It should be fine, this is a very simple operation. No worries. Be sure to review the "Related Questions" below for extensive information about the Windstar intake manifold -including links to plenty of instructions on removing the upper intake manifold.
Where is the egr valve located on a 2000 ford windstar?
The EGR valve on a 2000 Ford Windstar is located on the intake manifold near the firewall. It is typically located to the left of the main throttle body or slightly lower than the throttle body. On the passenger side it is located on the side of the intake manifold closest to the firewall. On the driver side it is located on the side of the intake manifold closest to the engine.
Intake manifold bolts torque ford windstar?
2000 3.8 Lower intake manifold (manifold to cylinder head) 1st step is 44 inch pounds, 2nd step is 89 inch pounds. This must be done in sequence.
What is the torque for intake manifold on a 350 Chevy?
The 350 cubic inch Chevrolet intake manifold bolts have a torque specification of Haiti pounds psi. The bolts should be torqued at 40 pound intervals.
