Just go here for all the info you need! I'd make it a Favorite too! http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/19/f6/75/0900823d8019f675.jsp
Pattern (work it gradually in 3 passes): 10-6-2-3-7 9-5-1-4-8 Tightening torque : 59-64 lb-ft (80 - 87 N·m)
Ford CFord Cylinder Head Torque Specificationsylinder Head Torque Specifications
51 lbs
Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .
I have a 1.6 L motor, it was; torque to 21, then torque to between 51 and 54 lbs. completely loosen bolts then repeat tightening pattern above.
The specification calls for initial tightening to 14 ft/lbs of torque, then GM uses a torque angle specification of 30 degrees from there. This requires a special tool that mounts between the socket and the ratchet. It is indexed and one end is held in place with a clamp. The pointer is then "zeroed" and the bolt is tightened slowly until the pointer moves 30 degrees as measured by the special tool. Be careful...over tightening these bolts can pull the threads out of the cylinder head.
The cylinder had bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
yes
maruti 800 2002 tightening torques of cylinder head
The cylinder head bolt torque specs for a Mitsubishi 2.0 or 2.6 is 65 to 72 ft. lbs. cold. Torque sequence is as follows.
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
torque specs in Nm and tightening esquence