That would be called the spindle.
The ball joints are riveted or pressed into the upper and lower control arms, then the spindle is bolted to the ball joints.
The ball joint in a vehicle is used to pivot between the wheel and the suspension. There are usually and upper ball joint and a lower ball joint.
They would be connected to two control arms, one upper control arm and one lower control arm.
The upper arm is the humerus, the lower arm is made up of the radius and ulna. The joint connecting the upper is called the humeroulnar joint.
you will probably need a ball joint press and a splitter
how do i change a lower ball joint on a 1992 ranger 2wd
what i know you can't take that ball joint to upper control arm but if you buy the upper control arm the ball joint comes with it.
it's a whole lot cheaper to replace the whole wheel bearing set. The wheel bearings have nothing to do with the ball joints. The ZX2 uses McPherson struts and only have a ball joint on the lower end of it. The upper end is attached to the shock tower with a large bushing. The ball joint stud attaches to the bottom of the spindle assembly and the ball joint assembly is attached to the lower control arm with two bolts.
I believe you can change just the ball joint on the lower control arms , the upper ball joints come with a new control arm
yes Yes, this is a good idea as both parts have taken the same amount of strain.
how do you change the upper and lower ball joint on a 95 s10 pick up truck 4 cylinder rear wheel drive
Chicken legs are essentially the same as human legs, only smaller, so the joint between the upper leg and the rest of the body is a ball-and-socket joint, while the upper leg to lower leg joint is a hinge joint.