0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is there valve clearance on a 1987 Nissan Maxima?
The 1987 Nissan Maxima VG30E engine uses hydraulic valve adjusters (also known as "cam followers") which cannot be adjusted. Therefore, there is no specific valve clearance. If you hear valve noise, it could indicate that there's either excessive wear of valve train parts or clogged hydraulic adjusters.
What is the Valve clearance settings and adjustment for a 1987 Honda 350 TRX ATV?
.003 on intake and exhaust
Where is the orifice tube located on 1987 Dodge Dakota?
A 1987 Dakota uses an expansion valve, not an orifice tube.A 1987 Dakota uses an expansion valve, not an orifice tube.
Where is the PCV valve located in a 1987 Nissan Sentra?
You can find the PCV valve for your 1987 Nissan on top of the engine. The PCV valve will be near the air filter housing.
Where is the PCV valve on a 1987 Chrysler LeBaron 2.2?
It is on the center rear of the valve cover.
Where is the PCV Valve on a 1987 Nissan Stanza?
It is at the top of the valve cover. Hope that heps!
Where is the PCV valve on a 1987 Toyota Corolla fx16?
The PCV valve on a 1987 Toyota Corolla FX16 is located behind the alternator. It is under the intake manifold.
Where is the PCV valve located on a 1987 Chevy Celebrity?
Its on the upper engine in front of the valve cover
Where is the modulator valve on a 1987 Ford LTD Crown Victoria?
If you mean the modulator valve for the transmission its on the side of the transmission. Under the car.New Answerthe 1987 ford crown vic with a AOD overdrive transmission does not have a modulator valve
Where is the PCV valve on a 1987 Nissan hardbody Pickup Z24i engine?
On a 1987 Nissan Hardbody Pickup, the PCV valve is located between the alternator and the oil filter. The valve can be seen when the oil filter has been removed.
Replacing PCV valve 1987 ford ranger?
The pcv valve is located on the top of the valve cover. It is a plug in type and just pulls out.
Your 1987 Toyota pickup idles rough and smokes a lot until engine is warm what could be the cause of this?
The valve guides and seals are worn, allowing a mist of oil to be drawn into the combustion chambers when the engine is cold. Once the engine warms up, the valve stems expand, reducing the clearance between them and their guides, effectively cutting off the flow of oil mist. The remedy for this is to have a valve-job performed on the engine.
